Part time 4×4 to full time 4×4 conversion kits?

Are there any relatively inexpensive solutions for changing an 96′ jeep cherokee with part time 4 wheel drive, to full time?

, , , , , ,

3 Responses to Part time 4×4 to full time 4×4 conversion kits?

  1. scout80xj November 5, 2010 at 4:54 am #

    You have the Command-Trac (NP231) transfer case which is a part time transfer case only transfer case. You need a Selec-Trac transfer case (NP242) which is part time OR Full time. So basically you need a new NP242 transfer case.

  2. jj November 5, 2010 at 4:54 am #

    In addition, the different transfer cases may require different drive shaft lengths.

  3. fbdfb d November 5, 2010 at 4:54 am #

    While this is not that difficult but you do need to know what the input splines are because an older cherokee NV241(slec trac) I believe is a 21 spline while the newer ones off liberties have the 23 Spline, The clutch packs they put in the NV241 on older ones could have gone to crap so I would be sorta careful if you go cheap and buy from a junkyard! you should not need a longer driveshaft for this installation as the NV241 is not much bigger then the NV231